Sleep when idle

Opt an app into stopping after it has had no requests for a set time. A sleeping app uses no memory or CPU. The next request to its domain starts it again. Off by default, per app.

How it works

• A check runs every minute. An app sleeps when its last request, or the moment you turned sleeping on or last woke it, is older than the idle time you chose (5 minutes to 7 days). Request activity comes from the same per-app request metrics the dashboard charts use.
• Sleeping stops the app the same way Stop does. Its settings, domains, secrets and volumes stay.
• While asleep, the app's domains answer a short "Waking up" page that retries on its own. The first request starts the app, so the first visitor waits for the cold start (the container start plus its readiness time, usually a few seconds to a minute).
• Starting the app by hand clears the sleeping state. Turning sleep off wakes the app first.

For API callers that cannot retry an error page, turn on hold requests while waking (apps sleep enable --hold): the request waits for the start and is replayed. See Functions.

Limits

• Needs request traffic through the built-in ingress. An app that is only reached over a pinned host port, a TCP stream, or from other apps is not seen as active and would sleep while in use, so leave it off there.
• Background work and scheduled tasks do not count as activity.
• Apps with a deploy freeze or in a protected environment sleep and wake like any other app, since neither changes what runs.

CLI

levelrail-cli apps sleep enable web --after 30m
levelrail-cli apps sleep status web
levelrail-cli apps sleep wake web
levelrail-cli apps sleep disable web

Dashboard

App, Deploys: the Sleep when idle card has the switch, the idle minutes, and a Wake now button while the app is asleep.

API

GET and PUT /api/v1/apps/{name}/sleep and POST /api/v1/apps/{name}/sleep/wake. PUT and the wake route need the deploy ability, GET needs read. See the API reference.